Do you know how a roller coaster works?

iw_inundaweb
by iw_inundaweb 02 Mar

Any movement in a roller coast is a result almost exclusively of the action of gravity force, because the car doesn’t have na engine. For this reason, the path starts with a big decline which generate the inicial push so the car can travel the rest of the path. Following you can understand the stages of a roller coaster:

Gravity

The inicial acceleration, which is obtained in the first decline, is crucial to define the rest of the path.

Stored energy

At the top of the roller coaster, the car accumulates potential energy, which during the decline turns into kinetic energy thought the action of gravity force. However, part of that energy is lost in the form of heat, due to friction with rail and air, and the result is a gradual decreasing of speed and maximum altitude that the car can reach.

Controlled movement

These equipaments don’t have sensors to controle the flow, but they can be stopped in strategic locations by an external brake, to avoid collisions. The curves, where the car runs at high speed, must be tilted towards inside to increase the contact with the rail and to prevent the car from escaping through thee tangent.

Initial push

To lift the car to the top of the roller coaster, a rotatory chain is used in the middle of the rail, in the begning of the path. Hooks tied at the bottom of the car are fixed in the chain when the car passes over it. This is when the car receives some type of propulsion.

Forces action

In looping, passengers lower their heads. So the car keeps on the rail, without falling down, the centripetal and gravity forces must act (the first one pull the car toward the centre).

Correct calculation

The looping height is always proportional to the decline traveled by the car: the bigger the previous decline, the higher can be the looping. If the calculation is done in a wrong way, the accleleration of the car might not be enought to overcome the centripetal and gravity forces, and then the car falls down.

Last stop

When the car is approaching to the end of the path, a sensor detects its arrival and activate the brake system. It works with clamps fixed to rail and between them there is a blade fixed to the bottom of the car. When the clamps are closed, they compress the blade and brake the car.

Leave your comment :

Leave a Reply